One thing to note is that the document parameters are accessible only within the document, while the project parameters are global to all the documents within the project, therefore parameters such as the ones you have shown in the image will be better suited at a project rather than at the document level. Representing decades of innovation and development, Altium Designer empowers a truly unified design environment, uniting teams worldwide with every aspect of the PCB design process. exactly the same as the NES controller, except it has two 4021s inside. Altium Designer is the most comprehensive, modern, end-to-end solution designed for PCB designers and the number one choice among engineers and designers worldwide. The vias will avoid the objects if the via conflict the DRC. 1st - Schematic: Import your OrCAD design (refer to Orcad Designs and Libraries Files section). The import process is a two stage process. The next step to do is to configure Altium to use these files when you want to create a new Project/schematic/PCB.Ĭlick on top left DXP menu then Prefences/New Documents Defaults, and set the path to the folder where you have your templates.ĭo not forget to scroll all the way to the bottom to set the Free Documents defaults, otherwise you will only have your template used when you create a new document within the project. The simplest half-adder design, pictured on the right, incorporates an XOR gate. Add/Remove Vias: When you add copper areas at two and more layers which are having same net, you can add multiple vias for the copper fill area, just click the Add/Remove Via button, then set the via parameter. Create a single project linking imported OrCAD Schematic Project and imported PADS/Allegro PCB Project. After which all you need to do is save it in a template folder of your choice. With the Schematic Project open in Altium add the PCB file to the schematic project by right clicking on the Project in the Project Panel and selecting 'Add Existing to Project.'then selecting the PCB you have copied and pasted from the imported PCB project folder. As the designer, you need to be able to focus your attention and apply the design constraints onto a signal that travels from this point on the board to that point on the board. The easiest way to do so is to start from a known project that you know is good, and you know it contains all the settings you need, and clear all the stuff you don't need out of it. This file will contain all of your default setting, parameters, and so on. The easiest method to achieve what you are after, is to create a blank template file.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |